Marine Duty Brake - Winch Brake - 14.458

Emco Marine duty stands approved IP – 66 protection by The Electrical Research & Development Association ( ERDA ). These are specially designed and recommended for Industries manufacturing shipyard and Docks, and in other areas like Cement, Mining where protection is against water and dust. These brakes are electromagnetically actuated single disk with two friction surfaces. The braking power is applied by means of compression springs. The braking torque is generated in the power off state or in event of power failure condition.

Features

1	IP 65 protection, IP 66 protection, IP 56 protection
2	IP 67 protection available on request
3	Fail safe
4	Torque up to 2500 Nm
5	Non asbestos friction linings
6	Twin friction surfaces
7	Low inertia rotors
8	Class ‘F’ coil insulation
9	Hard chrome plated armature plates and flanges
10	Tacho mounting provision possible
11	German low-wear non asbestos lining available on request
12	Screw type manual release
13	Square type hub for manual cranking on request